Design and Construction of Corn Sheller Machine to the Suitability of Grain Particle Size for Poultry Feed Raw Materials

Mukhsin Anami; Indah Widanarti

Mukhsin Anami Universitas Musamus
Indah Widanarti Universitas Musamus

Keywords: corn sheller, poultry feed raw materials, engine design

Abstract

ABSTRACT

The aim of this research is design a machine for corn sheller which the results canbe used as raw material for animal feed, especially poultry. The results of thedesign the corn shellerusing a power drive motor AC electric one phase 3/4 Hp. The main components of the engine used are frames, hoppers, crushing chambers,filters, output lines, shafts and bearings. Based on the results of the machine worktest, the engine capacity is 13.13 kg / hour with the results of the analysis ofgranules held by mesh 10 is 70.56%, retained by mesh 18 is 13.20% and passmesh sieve is 16.24%. The material used in this study was dry corn grains with amoisture content of 10.5%. The resulting particle grain size is 2 mm, 1 mm and inthe form granules smooth, the granules are already very good for poultry feed rawmaterials. The results of the economic analysis of the machine designed wereobtained that the cost needed to break 1 kg of dry corn grains was Rp. 2361.

References

Alamsyah. R. (2005) Pengolahan Pakan Ayam dan Ikan Secara Moderen. Bogor:Penebar Swadaya.
[BPS] Kabupaten Merauke Dalam Angka. 2018. Data Populasi Unggas menurut Kecamatan dan Jumlah Unggas di Kabupaten Merauke (ID) : BPS.
[BPS] Kabupaten Merauke Dalam Angka. 2018. Data Luas Panen. Produksi dan Produktifitas Jagung menurut Kecamatan di Kabupaten Merauke (ID) :BPS.
[BSN] Badan Standarisasi Nasional 1995. Standar Nasional Indonesia tentang Jagung Bahan Baku Pakan SNI 01-4483-1998 Jakarta (ID): BSN.
Darun. (2002). Pengantar Mekanisasi Pertanian. Fakultas Pertanian Universitas Islam Sumatra Utara Medan.
Erinofiardi. (2011). Desain Umur Bantalan Carrier Idler Belt Conveyor PT. Pelindo II Bengkulu. Jurnal Teknik Mesin.Volume 8. (halaman 1).
Masniah..Syamsudin (2013) Pemanfaatan Jagung Dalam Pembuatan Aneka macam Olahan. Seminar Nasional Serealia.pp. 537-542.
McCabe. W.. Smith. J.. dan Hariot. P. (1992). Introduction To Agricultural Enginering. New York Toronto: Mc Grow Hill.
Ratna. (2013) Pengaruh Kadar Air Biji Jagung dan Laju Pengumpanan Terhadap Mutu Tepung Jagung Menggunakan Alat Penggiling Tipe Disk Mill. Jurnal Ilmiah Pendidikan Biologi .Volume 5. pp.8-13.
Riahana. N. (2005). Teknologi Pengolahan Jagung. (ID): Balai Besar Penelitiandan Pengembangan Pasca Panen. pp. 386-409.
Setiana.. Utomo.. Ramli. (2015).Pengaruh Ukuran Partikel Jagung Terhadap kecerahan Pati : In Vitro.(The effect of Corn Particle Size on Starch Digestibility : In Vitro). (ID): Buletin Makanan Ternak. Halaman 102Volume 1 (27-35).
Sularso. (2002). Dasar Perencanaan dan Pemilihan Elmen Mesin. Jakarta: Pradnya Paramita.
Wirakarta kusuma. (1992). Peralatan dan Unit Proses Industri Pangan. Bogor:Institut Pertanian Bogor.